Time Displacement controls

Adjust the following controls for the Time Displacement effect:

Time Displacement Layer

Specifies the layer to use as the displacement map.

Max Displacement Time (sec)

Sets the maximum time, in seconds, from which pixels are replaced, before or after the current time. Note that only luminance values of 0 or 255 (maximum darkness and maximum brightness) produce the maximum time. All other luminance values produce times less than the maximum time.

Time Resolution (fps)

Sets the number of frames per second in which to replace pixels. Typically, this value should not be greater than the frame rate of the affected layer. Increasing Time Resolution can significantly increase rendering time.

Stretch Map to Fit

Resizes the Time Displacement Layer to match the dimensions of the layer you are distorting. If this option is not selected, the time displacement layer is centered in the composition.